The GolfWorks Grip Rib Kit - (30 Pack)

Adding A Rib/Reminder Has Never Been So Easy

The GolfWorks Rib Pack allows you to correctly align and easily install a rib inside any golf grip creating a “reminder” that will facilitate correct and consistent hand placement on every club in your bag.

Pre-installing the rib onto the golf shaft allows for the grip logo to be installed in any position (logo up or logo down) depending on the golfers preference.

Each rib is 0.035” thick, which is slightly less than the USGA 0.040” maximum allowable rib thickness.

Included in the pack are two alignment plugs; one for steel and one for graphite shafts.  The alignment plugs reduce the possibility of misaligning the rib during installation.

Installation

STEP 1 Simply set the face angle into the required position (while inserted into a grip clamp) and install the plug with the centre alignment stripe at 90º.

STEP 2 When the alignment plug is installed, simply rotate the club 180º in the grip clamp until the alignment strip is again at 90º.  Peel the backing paper from the rear of the rib to expose the adhesive and attach the rib onto the butt end of the golf shaft.

STEP 3 Each rib features a printed alignment line to further ensure the rib is installed correctly.  When applied, remove the alignment plug. 

STEP 4 Install the grip as per the usual fitting method.

Each rib is 0.035” thick, 0.25” wide and 9” in length.  Each rib pack contains two alignment plugs (one for steel and one for graphite shafts) and 30 individual golf grip ribs.

Key Features Of Ribs

•Grip ribs ensure consistent hand placement on every club.

•A rib can be placed at any position on the shaft, allowing for strong, neutral or weak grip positions.

•Grip logos can be positioned up or down with rib installed.

•Rib thickness of 0.035" is close to but not exceeding the USGA limit of 0.040".

•A rib can be installed in any rubber/cord, undersize, standard, midsize or jumbo golf grip.

•Much easier to install correctly, rather than ribbed golf grips.

•30 ribs per pack.

•Alignment plugs included - steel and graphite. 

The GolfWorks Grip Rib Kit Specifications

Brand:

The GolfWorks

Model:

Grip Rib Kit - (30 Pack)

Gender:

Unisex

Weight:

2.5g Per Rib

Size:

0.035” Thick, 0.25” Wide and 9” in Length

Colour:

Clear